Aprilaire 8570 Spécifications télécharger pdf (Page 5)

(2) OPEN THE THERMOSTAT

Use your hands to pull the thermostat face off of the base. Separate one side at a time. There are latches on

either side of the thermostat.

If needed, the thermostat can be pried from the base by inserting a flat-head screwdriver (see Figure 3).

- 4 - - 5 -

CAUTION

Loss of internal programs

may result from static

discharge to thermostat

circuit board. Avoid

touching the circuit board

and touch a grounded

metal object before

handling the thermostat.

(3) MOUNT THE THERMOSTAT BASE TO THE WALL

1. Place the wire opening in the base over the wire entry

hole in the wall. Level the base (for appearance only)

and mark the screw locations. See Figure 4.

2. Use the supplied screws and wall anchors to mount

the thermostat to the wall. It is recommended that wall

anchors be used for installation to drywall/sheet rock.

• Drill a 3/16" hole for wall anchors.

• Drill a 3/32" starter hole for screws only.

3. For junction box mounting, screws are field supplied.

The thermostat can be installed on a vertical j-box.

4. Seal the wire entry hole(s) with caulk, drywall putty

or insulation to prevent drafts from inside the wall

cavity from affecting thermostat performance.

CAUTION

Minimize wire entry hole size and seal the hole – drafts from inside the wall could affect temperature readings.

INSERT SCREWDRIVER INTO 1 OF

4 SLOTS (2 ARE ON THE TOPSIDE,

2 ARE ON THE BOTTOM SIDE)

USE THE SCREWDRIVER TO SEPARATE THE

HOUSINGS. REPEAT ON THE REMAINING 3 SLOTS.

NOTE: THE HOUSINGS WILL NOT COMPLETELY

SEPARATE. PULL THE HOUSINGS APART WITH

YOUR HANDS TO COMPLETELY SEPARATE.

Figure 4

Figure 3

90-1027

1 2 3 4 5 6 7 8 9 10 ... 24 25

Pas de commentaire

Aprilaire 8570 Spécifications Page 5